Filter
Top Products
Repeater Port Configuration Screen
2H23-50R/2H33-37R User’s Guide 5-69
MODE PORT STAT. (Toggle)
Used to enable (turn on) or disable (turn off) the port. To set the port to
operating mode, refer to Section 5.19.2.
SET ALL PORTS (Selectable)
Used to select operating mode for all the ports on the connector
simultaneously. This field steps through the following selections:
Auto-Neg., 10Base T, and 100Base-TX. To set all networks to the same
operating mode, refer to Section 5.19.3.
CONNECTOR # (Selectable)
Selects the front panel connector to which the settings will be applied.
5.19.1 Setting the Port Operating Mode
To set the operating mode for one or more network ports, proceed as
follows:
1. Use the arrow keys to highlight the CONNECTOR # field.
2. Use the SPACE bar to step to the appropriate connector number.
3. Use the arrow keys to highlight the MODE DESIRED OPER. field
of the network being configured.
4. Use the SPACE bar to step to the appropriate Operating Mode
(Auto-Neg, 10Base-T, or 100Base-TX).
5. If setting the operating mode on other ports, repeat steps 3 and 4 for
each one and then proceed to step 6.
6. Use the arrow keys to highlight the SAVE command.
7. Press ENTER. The message “SAVED OK” displays and all operating
mode settings are saved.