Filter
Top Products
SNMP Community Names Screen
2H23-50R/2H33-37R User’s Guide 5-35
5.8.1 Establishing Community Names
The password used to access Local Management at the Password Screen
must have super-user access to view and edit the SNMP Community
Names screen. Using a password with read-only or read-write access does
not allow the user to view or edit the SNMP Community Names screen.
To establish community names, proceed as follows:
1. Use the arrow keys to highlight the Community Name field adjacent
to the selected access level.
2. Enter the password in the field (maximum 31 characters).
3. Press ENTER.
4. Repeat steps 1 through 3 to modify the other community names.
5. Use the arrow keys to highlight the SAVE command at the bottom of
the screen and press ENTER. The message “SAVED OK” displays.
The community names are saved to memory and their access modes
implemented.
NOTE
Any community name assigned in the SNMP Community
Names screen is a password to its corresponding level of
access to Local Management.
The community name assigned super-user access is the only
one that gives the user complete access to Local Management.
NOTE
Exiting without saving causes a “NOT SAVED?” message to
display. Edits are lost if they are not saved before exiting.