Filter
Top Products
LOCAL MANAGEMENT
4-2
Cabletron supplies an RJ45 Cable Kit with the MicroMMAC-T. This kit
includes a UTP console cable with RJ45 connectors on each end. It also
provides adapters for DB9 or DB25 connections. Refer to the RJ45 Cable
Kit Instruction Sheet for adapter pinouts and additional instructions.
The following sections explain how to attach the console cable to the
management terminal.
4.1.1 Attaching the Management Terminal
NOTE: To view booting and diagnostic test information during power-up
or reset, connect the terminal to the MicroMMAC-T ‘s COM 2 port. See
Section 5.3 for more information about POWER UP DIAGNOSTIC tests.
To attach a management terminal to the MicroMMAC-T:
1. Attach the connecting cable’s male RJ45 connector to either the
COM 1 port or the COM 2 port on the MicroMMAC-T as shown in
Figure 4-1.
2. Attach the female end (25-pin or 9-pin) to the COM port on the
terminal.
Figure 4-1. Management Terminal Connection
4.1.2 Management Terminal Setup Parameters
Table 4-1 lists the setup parameters for the Local Management terminal. If
you are using a Digital Equipment Corporation VT terminal, press F3 to
access the Setup Directory. For PC emulations of VT terminals, refer to the
emulator’s documentation for setup parameters.
TOKEN RING HUB
WITH
LANVIEW®
SUPPORTING 100 OHM STP CABLE
MicroMMAC-24T
MANAGEMENT TERMINAL
COM PORT
COM 2 RJ45 PORT
CONSOLE CABLE