Filter
Top Products
Appendix C: Using FTP 123
DMS-100 Family EIU User Guide TELECOM12
If you need to find out the IP address of a SuperNode host, refer to the
following tables:
• table IPNETWRK for address of the CM
• table IPHOST for addresses of all other SuperNode hosts
Tutorial: basic FTP operations
This section provides a set of procedures for using FTP on the DMS-100
switch to transfer files to and from the DMS-100 switch. Use these procedures
as either reference or as a tutorial.
The procedures do not exercise all of the FTP commands available on the DMS
client. The purpose of the procedures, as they are presented here, is to
introduce you to common operations and commands.
Note: The procedures assume that you are at the CI level, and using the
DMS-100 switch as the FTP client. The purpose of the session with the
host is to transfer files between the host and a DMS-100 switch.
Procedure 1 Establishing an FTP session
Step Action
1 Start the FTP tool by typing
> ftp ‘nnn.nnn.nnn.nnn’
and pressing the Enter key.
where
nnn is the portion of the IP address that identified the node
Example:
> ftp ‘47.208.11.210’
Example of a MAP response:
Allocated a Session ID Sucessfully
220 bmerh538 FTP server (Version 1.7.212.2 Tue Apr 21
12:14:46 GMT 1998) ready
2 Enter the host userID
ftp> user_id
and pressing the Enter key.
where
user_id is a valid userID for that host
3 Enter the host password
ftp> passwd
and pressing the Enter key.