Filter
Top Products
Appendix D: Using telnet 143
DMS-100 Family EIU User Guide TELECOM12
Procedure 13 Telnetting into a switch for MAP session access (CSP05 and up)
Step Action
1 Go to the CI level of the MAP display.
2 Open table IPNETWRK by typing
>table IPNETWRK
and pressing the Enter key.
3 Determine the IP address for the CM.
4 Close table IPNETWRK by typing
>quit
and pressing the Enter key.
5 Open table IPHOST by typing
>table IPHOST
and pressing the Enter key.
6 Determine that there are enough TCP connections for the CM.
7 Close table IPHOST by typing
>quit
and pressing the Enter key.
8 Open an xterm window.
9 Telnet into the CM by typing
>telnet ip_addr
and pressing the Enter key.
where
ip_addr is IP address for the CM that you found at step 3
10 You have completed this procedure.