Filter
Top Products
The Configuration Screen
SEHI User’s Guide 7-13
2. Enter the subnet mask into this field. The format for this entry is
XXX.XXX.XXX.XXX with values for XXX being from 0 to 255.
3. Press ENTER.
4. Use the arrow keys to highlight the SAVE option, then press ENTER
or F6. The “SAVED OK” message appears indicating that the changes
have been saved to memory.
Setting the Default Gateway
The Default Gateway field allows the user to identify the router through
which the SEHI will be forwarding IP packets.
Use the following steps to set the Default Gateway:
1. Use the arrow keys to highlight the Default Gateway field.
2. Enter the gateway default mask in this field. The format for this entry
is XXX.XXX.XXX.XXX with values for XXX being from 0 to 255.
3. Press ENTER. If the entry is accepted as a valid default gateway,
“OK” appears to the right of the field.
4. Use the arrow keys to highlight the SAVE option, then press ENTER
or F6. The “SAVED OK” message appears indicating that the changes
have been saved to memory.
Using the Port Enable Override
Use the following steps to override the Disable Port settings and enable
all ports in the stack:
1. Use the arrow keys to highlight the Port Enable Override field.
2. Press ENTER to toggle from the default setting of “OVERRIDE
DISABLED” to “OVERRIDE ENABLED.”
3. The adjacent field displays “Y/N.” Enter Y to continue enabling all
ports, or N to discontinue the port enable override. The message
“PORT ENABLED” appears after Y is entered.
NOTE
The first time an attempt is made to exit the screen without
saving the changes, a “NOT SAVED?” message is displayed.
The edits are lost if the user proceeds to exit without saving the
changes.
SEHI Book Page 13 Friday, April 19, 1996 10:46 AM