Filter
Top Products
1-20
Selecting an Output Device (Select Output Device)
Basic Copying
1
IMPORTANT
• When the machine is operating in the Remote or Cascade Copy mode, you cannot use the Rotate
Collating, Rotate Grouping, Saddle Stitch, Shift (No. Key Entry), Booklet, Transparency Interleaving,
Mirror Image, Form Composition, Page Numbering, Interrupt Copy, and Sample Set.
• If you use Cover/Sheet Insertion with the remote or cascade copy mode, Auto Orientation is not performed.
• If you use the Image Separation with the remote or cascade copy mode, the layout of the final page of the original
cannot be set.
• If you power the remote copy printer back On, or reattach the Finisher, you need to refresh the settings of the remote
copy printer from the Additional Functions screen. (See “Confirming a Remote Device,” on p. 3-16.)
• If you connect the machine directly to other remote copy printers by crossover patch cord, you need to configure the
Ethernet driver as shown below. (See Chapter 2, “Settings Common to the Network Protocols,” in the Network Guide.)
- Auto Detect: Off
- Communication Mode: Full Duplex
- Ethernet Type: 100 Base-TX
NOTE
• In order for a device to be selected as a remote output device used for remote copying,
it must be stored in the Store Remote Device function on the Copy Settings screen.
(See “Specifying the Remote Copy Printer Settings,” on p. 3-14.)
• For cascade copying, the Paper Select screen of this machine is displayed. Select the paper drawer on the
machine that is loaded with the same paper size as the remote copy printers.
• To copy the original on this machine and another remote copy printer on the network at the same time
(cascade copying), the number of copies set for this machine and the number of copies set for the
remote copy printer are split in half and printed. If an odd number of copies is set, the machine you are
copying from will print one additional copy.
• If you select a remote copy printer before performing cascade copying, you cannot select copy settings that are
not supported by the remote copy printer. Also, if the finishers attached to this machine and the remote copy
printer are different, the finisher settings can only be set to the Collate and Group modes.
• When one remote copy or one cascade copy job is in progress, it is not possible to schedule another remote copy
or cascade copy job.
• For the selected remote copy printer, set the same Department ID and password as this machine.
(See Chapter 4, “System Manager Settings,” in the Reference Guide.)
• When one remote copy or one cascade copy job is in progress, if an error occurs in the remote copy printer,
an error message is displayed on the Job/Print monitor area of the touch panel display of this machine and
the remote copy printer.
• If you experience any problems when using the Remote or Cascade Copy, consult your local authorised Canon
dealer.