Filter
Top Products
103
Setting Various Functions
User’s Manual Settin
g
Functions from Menus
Setting a Password
[Other settings] - [Password settings]
Disables the projector unless the correct
password is entered.
Press the OK button to accept your setting
and then press the MENU button.
• [Off] is the factory default.
• You cannot set [On] unless you have com-
pleted [Register password].
Once you set a password, the password
entry screen appears at power-on.
Enter a 4-digit password consisting of a
combination of the [ ], [ ], [ ] / [ ] but-
tons.
If the password is valid, the projection
starts. If you enter a wrong password three
times, the power will be turned off.
• The power is also turned off if no password
is input for 3 minutes.
HDMI Component
Digital PC Analog PC
Off
The projector can be used even if no pass-
word is entered.
On
The projector cannot be used unless you
enter your password.
Other settings
System settings
Password settings
To Cancel the Password
Turn off the projector and unplug the power
plug.
Hold down the
MENU
button on the side control
and connect the power plug. Make sure to keep
holding down the
MENU
button until a beep
sounds. When the beep sounds, the password
is canceled. (The entered password is also
reset.)
To forcibly cancel the password from the remote
control, in standby state press the
MENU
button
3 times, then press the
POWER
button.