Filter
Top Products
132
Preparing the Remote Control
If the projector is connected to a network, projector error notification mails can be
received via a computer and a computer can be used to control the projector. Settings
related to the network connection can be made from either the projector side (P138) or
computer side (P142).
Depending on the method of network connection, preparation on the computer side may
be necessary. The following is an explanation of preparation on the computer side.
Connection Methods
Connect the projector to the computer via LAN.
• When the [Network function] setting of the projector is set to [Off] (Network Connections
is disabled), switch it to [On] to enable it (P138).
• Referring to “Checking Projector Information” (P110), check that the projector IP
address is not overlapped with other computers that are on the same LAN. When you
set the IP address of the projector, follow the instruction in “Configuring the Network
from the Computer” (P142) on the web screen or refer to “TCP / IP Setting” (P141).
• When you connect the computer to the network first time, it is also necessary to perform
settings on the computer. In this case, consult the network administrator regarding the
necessary settings.
In a network environment where a DHCP server is operating, choose [On] on the projector [DHCP]
screen to enable the DHCP function and connect it (P140).
LAN cable (not included)
(crossover or straight cable)
Hub or router, etc.Projector