Filter
Top Products
123
Installing / Removing the Lens Unit
Installation Manual Installation
■Removing the Lens Unit
1 Perform steps 1 to 5 of “Installing the Lens Unit” (P119 – P121) and remove the
sleeve.
2 Disconnect the lens cable from the lens connector.
3 Fix the lens cable as shown in the illustration and loosen the 4 screws to remove the
lens unit.
The 4 lens unit screws are attached to the lens unit and cannot be removed.
When pulling out (disconnecting) the lens cable, press the buttons on both sides of the lens
cable connector while pulling out the cable.