Filter
Top Products
98
Setting Various Functions
Selecting the Power Man-
agement Mode
[Power management mode]
You can turn off the lamp or projector auto-
matically in order to save power when the
projector is not in use.
Press the OK button to accept your setting
and then press the MENU button.
• [Off] is the factory default.
• During standby mode, the [POWER ON]
indicator and [STAND BY] indicator flash
alternately.
• You cannot enable the [Direct power on]
function (see the next item), if you select
[Off].
Skip the POWER Button
Operation
[Direct power on]
You can turn on the projector by connect-
ing the power cable without pressing the
POWER button.
Press the OK button to accept your setting
and then press the MENU button.
• [Off] is the factory default.
HDMI Component
Digital PC Analog PC
Off Disables the power management
mode.
Standby If no input signal is received for 30
seconds, the projector enters the
standby mode, turning off the lamp
five minutes after start of count-
down.
If it receives an input signal or is
operated during this period of 30
seconds, it resumes projection.
Exit If no input signal is received for 30
seconds, it displays the countdown
and turns off the projector after 5
minutes.
System settings
Power management mode
HDMI Component
Digital PC Analog PC
Off You need to press the POWER button
to turn on the projector.
On You can turn on the projector by con-
necting the power cable only.
• Before setting the direct power-on to
[On], be sure to set the [Power man-
agement mode] to [Standby] or
[Exit].
•
After turning off the projector, wait at
least 5 minutes before turning it on
again. It may shorten the lamp life if
you turn on the projector immediately
after turning it off.
System settings
Direct power on