Filter
Top Products
2-3
Cisco 10000 Series Router SIP and SPA Hardware Installation Guide
OL-13838-03
Chapter 2 Cisco 10000 Series Router SPA Interface Processor-600
Identifying Slots and Subslots for SIPs and SPAs
Slot/Subslot 1/0:
4jacket-1 card, 0 ports
Card is full slot size
Card is analyzed
Card detected 07:42:30 ago
Card uptime 0 days, 7 hours, 42 minutes, 31 seconds
Card idle time 0 days, 3 hours, 3 minutes, 17 seconds
Voltage status:
EEPROM contents, slot 1/0:
Controller Type : 1380
Hardware Revision : 1.0
PCB Part Number : 73-10771-01
Board Revision :
Deviation Number : 0-0
Fab Version : 01
PCB Serial Number : CSJ10497186
RMA Test History : 00
RMA Number : 0-0-0-0
RMA History : 00
Top Assy. Part Number : 800-27953-01
CLEI Code : UNASSIGNED
Product Identifier (PID) : 10000-SIP-600
Version Identifier (VID) : V00
LCMON version, slot 1/0
LCDOS (C10000 PowerQUICC-III Line Card MONitor Image : DEVELOPMENT BUILD
jkotelly-spumoni_lc /vob/lcdos/obj-c10k-pq3-lcmon 102
)
Built by jkotelly at Thu Nov 9 10:54:20 2006.
Reset reason 0x00000008 (PRE hard reset).
Operational Image version, slot 1/0
LCDOS (C10000 4 SPA Jacket Card Image (Spumoni) : DEVELOPMENT BUILD
BLD-mayflower_lc.lcdos-nightly-mayflower-c10k /vob/lcdos/ob
j-c10k-spumoni 102) major version 1189663592.
Built by ashah at Thu Sep 13 02:08:59 2007.
SW Version 4.0
Code MD5 068FBA5273DC8F598CC66E34D867A197
FPGA MD5 89C8DD3DCD939BDD43DB19D514416137
Expected Switchover Action: NO ACTION
ECC 1 bit errors since last cleared (dd hh mm ss) = 0 (0 days, 0 hours, 0 minutes,
0 seconds)
ECC 1 bit errors while up (total) = 0
Number of crashdumps recorded = 8
SPA Information:
subslot 1/0 SPA-5X1GE-V2 ok
SW Version 1.0
Expected Switchover Action: NO ACTION
Product Identifier (PID) : SPA-5X1GE-V2
Version Identifier (VID) : V01
PCB Serial Number : JAB105201VV
Top Assy. Part Number : 68-2616-01
Top Assy. Revision : D0
Hardware Revision : 1.1
CLEI Code : CNUIANAAAA
The Transceiver in slot 1 subslot 0 port 0 is ENABLED.
The Transceiver in slot 1 subslot 0 port 1 is ENABLED.
The Transceiver in slot 1 subslot 0 port 2 is ENABLED.
The Transceiver in slot 1 subslot 0 port 3 is ENABLED.
The Transceiver in slot 1 subslot 0 port 4 is ENABLED.
SPA Information:
subslot 1/1 SPA-5X1GE-V2 ok