Filter
Top Products
2-5
Cisco 10000 Series Router SIP and SPA Hardware Installation Guide
OL-13838-03
Chapter 2 Cisco 10000 Series Router SPA Interface Processor-600
Identifying Slots and Subslots for SIPs and SPAs
Controller Type : 1380
Hardware Revision : 1.0
PCB Part Number : 73-10771-01
Board Revision :
Deviation Number : 0-0
Fab Version : 01
PCB Serial Number : CSJ10497112
RMA Test History : 00
RMA Number : 0-0-0-0
RMA History : 00
Top Assy. Part Number : 800-27953-01
CLEI Code : UNASSIGNED
Product Identifier (PID) : 10000-SIP-600
Version Identifier (VID) : V00
LCMON version, slot 5/0
LCDOS (V122_33_2_31_SBK06-BOOT : DEVELOPMENT BUILD chandrav-lcmon
/vob/lcdos/obj-c10k-pq3-lcmon 114)
Built by chandrav at Sun Jun 15 13:55:54 2008.
Reset reason 0x00000008 (PRE hard reset).
Operational Image version, slot 5/0
LCDOS (C10000 4 SPA Jacket Card Image (Spumoni) : DEVELOPMENT BUILD
BLD-v122_34_sb_lc_throttle.lcdos-V122_33_3_10_SB-v122_34_sb_throttle
/vob/lcdos/obj-c10k-spumoni 102) major version 1219740068.
Built by richv at Tue Aug 26 04:44:51 2008.
SW Version 1.1
Code MD5 53E9196510CAE3216B1663318CA47620
FPGA MD5 89C8DD3DCD939BDD43DB19D514416137
Expected Switchover Action: NO ACTION
ECC 1 bit errors since last cleared (dd hh mm ss) = 0 (0 days, 0 hours, 0 minutes,
0 seconds)
ECC 1 bit errors while up (total) = 0
Number of crashdumps recorded = 3
SPA Information:
subslot 5/0 SPA-2XCHOC12/DS0 ok
SW Version 1.0
Expected Switchover Action: NO INFORMATION
Product Identifier (PID) : SPA-2XCHOC12/DS0
Version Identifier (VID) : V01
PCB Serial Number : PRTA6404025
Top Assy. Part Number : 68-3137-01
Top Assy. Revision : 02
Hardware Revision : 0.17
CLEI Code :
The Transceiver in slot 5 subslot 0 port 0 is ENABLED.
The Transceiver in slot 5 subslot 0 port 1 is ENABLED.
For more information about SIP commands, see the Cisco 10000 Series Router SIP and SPA Software
Configuration Guide.
Specifying the Location for a SPA
A Cisco 10000 SIP-600 supports four subslots for the installation of SPAs. The SPA subslots are
numbered from 0 to 3, as shown in
Figure 2-2. The number for each SPA subslot is indicated by a small
numeric label on the SIP faceplate.
SPAs in the Cisco 10000 series router use an addressing format that specifies the physical location of the
SIP, SPA, and interface in the format slot/subslot/port, where: