Filter
Top Products
5-3
Cisco 10000 Series Router SIP and SPA Hardware Installation Guide
OL-13838-03
Chapter 5 Installing and Removing a SIP
Online Insertion and Removal of a SIP
Deactivating a SIP
To deactivate a SIP and its installed SPAs prior to removal of the SIP, use the following command in
global configuration mode:
Reactivating a SIP
Once you deactivate a SIP, whether or not you have performed an OIR, you must use the no hw-module
slot shutdown command in global configuration mode to reactivate the SIP.
If you did not issue a command to deactivate the SPAs installed in a SIP, but you did deactivate the SIP
using the no hw-module slot shutdown command, then you do not need to reactivate the SPAs after an
OIR of the SIP. The installed SPAs automatically reactivate upon reactivation of the SIP in the router.
For example, consider the case where you remove a SIP from the router to replace it with another SIP.
You reinstall the same SPAs into the new SIP. When you enter the no hw-module slot shutdown
command on the router, the SPAs automatically reactivate with the new SIP.
To activate a SIP and its installed SPAs after the SIP has been deactivated, use the following command
in global configuration mode:
Verifying the Status of a SIP
To view the status of a SIP, use the show diag command in privileged EXEC configuration mode.
Router# show diag 1/0
Slot/Subslot 1/0:
4jacket-1 card, 0 ports
Card is full slot size
Card is analyzed
Card detected 07:42:30 ago
Card uptime 0 days, 7 hours, 42 minutes, 31 seconds
Card idle time 0 days, 3 hours, 3 minutes, 17 seconds
Voltage status:
EEPROM contents, slot 1/0:
Controller Type : 1380
Hardware Revision : 1.0
PCB Part Number : 73-10771-01
Board Revision :
Command Purpose
Router(config)# hw-module slot
slot
shutdown
Shuts down any installed interfaces, and deactivates the
SIP in the specified slot, where:
• slot—Specifies the chassis slot number where the
SIP is installed.
Command Purpose
Router(config)# no hw-module slot
slot
shutdown
Activates the SIP in the specified slot and its installed
SPAs, where:
• slot—Specifies the chassis slot number where the
SIP is installed.