Filter
Top Products
5-6
Cisco 10000 Series Router SIP and SPA Hardware Installation Guide
OL-13838-03
Chapter 5 Installing and Removing a SIP
SIP Installation and Removal
Step 1 Attach an ESD-preventive wrist or ankle strap and follow its instructions for use.
Step 2 Remove the blank filler plates from two slots and set them aside.
If you are replacing legacy line cards with a SIP, perform these tasks:
a. Shutdown both slots in which you are installing the SIP using the hw-module slot slot
shutdown command.
b. Enter the no card command on both slots.
c. Remove the legacy cards from the slots.
d. Proceed to Step 3.
Step 3 Grasp the faceplate of the SIP with one hand and place your other hand under the SIP (to support the
weight of the SIP) and position the SIP in front of the appropriate line card slots.
Caution The Cisco 10000 SIP-600 weighs 10 lb (4.6 kg). Use two hands when handling the SIP.
Step 4 Carefully align the upper and lower card guides on the SIP with the upper and lower guides in the chassis
and slide the SIP into the module slot until you can feel it begin to seat in the backplane connectors, as
shown in
Figure 5-2.
Note A SIP is not supported if the SIP is installed in even slots.
Step 5 Pivot the SIP ejector levers to the open position as shown in Figure 5-2.