Filter
Top Products
5-5
Cisco 10000 Series Router SIP and SPA Hardware Installation Guide
OL-13838-03
Chapter 5 Installing and Removing a SIP
SIP Installation and Removal
The Transceiver in slot 1 subslot 1 port 3 is ENABLED.
The Transceiver in slot 1 subslot 1 port 4 is ENABLED.
SPA Information:
subslot 1/2 SPA-5X1GE-V2 ok
SW Version 1.0
Expected Switchover Action: NO ACTION
Product Identifier (PID) : SPA-5X1GE-V2
Version Identifier (VID) : V01
PCB Serial Number : JAB1042060D
Top Assy. Part Number : 68-2616-01
Top Assy. Revision : D0
Hardware Revision : 1.1
CLEI Code : CNUIANAAAA
The Transceiver in slot 1 subslot 2 port 0 is ENABLED.
The Transceiver in slot 1 subslot 2 port 1 is ENABLED.
The Transceiver in slot 1 subslot 2 port 2 is ENABLED.
The Transceiver in slot 1 subslot 2 port 3 is ENABLED.
The Transceiver in slot 1 subslot 2 port 4 is ENABLED.
SPA Information:
subslot 1/3 SPA-5X1GE-V2 ok
SW Version 1.0
Expected Switchover Action: NO ACTION
Product Identifier (PID) : SPA-5X1GE-V2
Version Identifier (VID) : V01
PCB Serial Number : JAB110202GA
Top Assy. Part Number : 68-2616-01
Top Assy. Revision : E0
Hardware Revision : 1.1
CLEI Code : CNUIANAAAA
The Transceiver in slot 1 subslot 3 port 0 is ENABLED.
The Transceiver in slot 1 subslot 3 port 1 is ENABLED.
The Transceiver in slot 1 subslot 3 port 2 is ENABLED.
The Transceiver in slot 1 subslot 3 port 3 is ENABLED.
The Transceiver in slot 1 subslot 3 port 4 is ENABLED.
Router#
SIP Installation and Removal
This section provides step-by-step instructions for installing and removing a SIP.
Warning
When performing the following procedures, wear a grounding wrist strap to avoid ESD damage to the
SIP. Some platforms have an ESD connector for attaching the wrist strap. Do not directly touch the
midplane or backplane with your hand or any metal tool, or you could shock yourself.
Caution Install or remove only one SIP at a time. Be sure to verify that each SIP is fully installed and secured
before installing another SIP. Use of excessive force can damage the router or SIP.
Installing a SIP
To install a SIP, follow these steps: