Filter
Top Products
6-6
Cisco 10000 Series Router SIP and SPA Hardware Installation Guide
OL-13838-03
Chapter 6 Installing and Removing a SPA
SPA Blank Filler Plates
• If there is no indication that an FPD upgrade is under way, see Chapter 7, “Troubleshooting the
Installation.”
Using show Commands to Verify SPA Status
Table 6-1 describes some show commands to verify that SPAs are configured and operating correctly.
SPA Blank Filler Plates
SPA blank filler plates are available to fill an unused SPA subslot.
When a SPA subslot is not in use, a SPA blank filler plate must be installed in the empty subslot to allow
the router or switch to conform to electromagnetic interference (EMI) emissions requirements and to
allow proper airflow across the SPAs. If you plan to install a new SPA in a subslot that is not in use, you
must first remove the SPA blank filler plate.
Table 6-1 show Commands to Display SPA Information
Command Descriptions
router(config)# show
running-config
Displays the router’s running configuration and interfaces available
in the system, including the SPA interfaces.
router(config)# show hw-module
subslot all oir
Displays the operational status of all SPAs.
router(config)# show diag Displays the SPA type in the specified slot and subslot, SPA
operational state, number of ports, hardware revision, part number,
transeiver state if initialized and EEPROM contents.
router(config)# show hw-module
subslot all fpd
Displays the field-programmable devices (FPD) version
information of SPAs.
router(config)# show version
Displays the Cisco IOS software version, names and sources of
configuration files, and boot images.
router(config)# show interfaces
Displays SPA configuration and statistics information.