Filter
Top Products
1
Doc. No.
Copyright © 1996
Cisco Systems, Inc.
All rights reserved.
7000 Series Route Switch Processor (RSP7000)
Installation and Configuration in
the Cisco 7000 Series Routers
78-2561-01
Product Numbers: RSP7000=, MEM-RSP-FLC8M=, MEM-RSP-FLC16M=,
MEM-RSP-FLC20M=, MEM-RSP-8M=, MEM-RSP-16M, MEM-RSP-24M,
MEM-RSP-32M(=), MEM-RSP-64M(=), and MEM-RSP-128M(=)
This document discusses the 7000 Series Route Switch Processor (RSP7000), which is a new main
processor module for the Cisco 7000 series routers: the Cisco 7000 and the Cisco 7010. The
RSP7000 combines all of the switched routing and high-speed switching functions required by the
Cisco 7000 series routers. (Refer to the section “What Is the RSP7000?” on page 3.)
The RSP7000 requires that your Cisco 7000 series router is running Cisco Internetwork Operating
System (Cisco IOS) Release 10.3(9), or later, Release 11.0(6), or later, or Release 11.1(1) or later.
Caution Using the RSP7000 in your Cisco 7000 series router might require that some currently
installed interface processors be upgraded to specific, compatible hardware versions; otherwise,
error messages and erratic system behavior might result. You can use the show diag command to
see which interface processors in your system need this hardware upgrade. For a complete list of the
potentially affected interface processors, their required hardware versions, and information on
upgrading your affected interface processors, refer to the document Verifying Interface Processor
Compatibility with the Cisco 7500 Series Investment Protection Program (IPP), Document
Number 78-2077-xx, where xx refers to the latest version of this document.
Document Contents
Following are the sections in this document:
• Product Descriptions, page 2
• Installation Prerequisites, page 7
• Installation Procedures, page 18
• Troubleshooting the Installation, page 23
• Reference Information, page 28
• Cisco Information Online, page 47