Filter
Top Products
7000 Series Route Switch Processor (RSP7000) Installation and Configuration in the Cisco 7000 Series Routers 41
Reference Information
Replacing a Flash Memory Card
It might become necessary for you to replace or install a Flash memory card in your RSP7000. The
RSP7000 has two PCMCIA slots: slot 0 (left) and slot 1 (right). (See Figure 9 on the following page.)
The following procedure is generic and can be used for a Flash memory card in either slot position.
A Flash memory card can be inserted and removed with the power on.
Following is the procedure for installing and removing a Flash memory card:
Step 1 Face the front panel of the RSP7000 (as shown in Figure 9a), and hold the Flash memory
card with the connector end of the card toward the slot.
Figure 9 Installing and Removing a Flash Memory Card (PCMCIA slot 1)
NORMAL
EJECT
SLOT 1
SLOT 0
a
H3089
b
NORMAL
EJECT
SLOT 1
SLOT 0
c
NORMAL
EJECT
SLOT 1
SLOT 0
UP
UP
UP