Filter
Top Products
7000 Series Route Switch Processor (RSP7000) Installation and Configuration in the Cisco 7000 Series Routers 17
Installation Prerequisites
Step 7 Before the system reboots with the new configuration, it displays the instructions you
entered for confirmation. If the instructions are not correct, enter n (no) then press Return
to cancel the process. To accept the instructions, press Return, or y then Return.
Configure using router-confg from 1.1.1.1? [confirm]
Booting router-confg from 1.1.1.1: ! ! [OK - 874/16000 bytes]
While the router retrieves and boots from the configuration on the remote host, the console
display indicates whether or not the operation was successful. A series of !!!! and [OK] (as
shown in the preceding example) indicates that the operation was successful. A series of...
and [timed out] or [failed] indicate a failure (which would probably be due to a network
fault or an incorrect server name, address, or filename). The following is an example of a
failed attempt to boot from a remote server:
Booting Router-confg ..... [timed out]
Step 8 If the display indicates that the process was successful, proceed to the next step.
If the display indicates that the process failed, verify the name or address of the remote
server and the filename, and repeat the preceding steps. If you are unable to retrieve the
configuration, contact your network administrator or refer to the end of this document for
instructions on obtaining technical assistance.
Step 9 Issue the write term (or show running-config) command to display the currently running
configuration on the terminal. Review the display and ensure that the configuration
information is complete and correct. If it is not, verify the filename and repeat the preceding
steps to retrieve the correct file, or use the configure command to add or modify the existing
configuration. (Refer to the appropriate software documentation for descriptions of the
configuration options available for the system and individual interfaces and specific
configuration instructions.).
Step 10 When you have verified that the currently running configuration is correct, issue the
copy running-config startup-config command to save the retrieved configuration in
NVRAM. Otherwise, the new configuration will be lost if you restart the system. This
completes the procedure for downloading (retrieving) the configuration file.
List of Tools and Parts
You need some or all of the following tools and parts to remove and replace an RSP7000. If you need
additional equipment, contact a customer service representative for ordering information.
• Number 2 Phillips or 3/16-inch, flat-blade screwdriver for the captive installation screws that
secure the RSP7000 in its slot.
• ESD-prevention equipment or the disposable ESD-preventive wrist strap included with all spares
and upgrade kits.
• Antistatic mat, foam pad, or bag for the removed RSP7000 (place the removed RSP7000 into an
antistatic bag if you plan to return it to the factory, or on an antistatic mat or foam if you are
replacing components and will reinstall the RSP7000)
If you are replacing SIMMs, you will need 60-ns SIMMs from an approved vendor