Filter
Top Products
2 7000 Series Route Switch Processor (RSP7000) Installation and Configuration in the Cisco 7000 Series Routers
Product Descriptions
Product Descriptions
This section describes the Cisco 7000 and Cisco 7010 routers, and the RSP7000.
What Is the Cisco 7000?
The Cisco 7000 is a seven-slot router chassis, which uses the new RSP7000 (and the 7000 Chassis
Interface [RSP7000CI]). The Cisco 7000 provides up to five interface processor slots, and can
accommodate the following CxBus-based interface processors: Fast Ethernet, Ethernet, Token Ring,
Fiber Distributed Data Interface (FDDI), channel attachment, multichannel, serial, and so forth. The
7000 RSP and interface processors are keyed with guides on the backplane to prevent them from
being fully inserted in the wrong slot.
Figure 1 shows the rear of the Cisco 7000 router. In the Cisco 7000, slot 5 (7000 RSP slot shown in
Figure 1) is reserved for the RSP7000, which contains the system processor and performs packet
switching functions, and slot 6 (7000 CI slot shown in Figure 1) is reserved for the RSP7000CI
board, which contains all of the environmental monitoring functions for the Cisco 7000. The
remaining five slots (slots 0 through 4) are for interface processors.
Figure 1 Cisco 7000 with RSP7000 and RSP7000CI Installed
H5288
Interface processor slots 0
1
2
3 4 RSP
7000
slot 5
RSP
7000CI
slot 6
Upper
power supply
Lower
power supply
I
O
DC FAIL
AC POWER
I
O
DC FAIL
AC POWER
Captive
installation screw
Captive
installation screw
EJECT
SLOT 0
SLOT 1
NORMAL
CPU HALT
RESET
AUX.
CONSOLE
ROUTE SWITCH PROCESSOR
ENABLE
ENABLE