Filter
Top Products
C-11
Cisco UCS C220 Server Installation and Service Guide
OL-25760-01
Appendix C RAID Controller Considerations
Embedded MegaRAID Controller
Disabling the Embedded RAID Controller in the BIOS
Caution Data migration from SW RAID to HW RAID is not supported and could result in data loss. Migrations
from SW RAID to HW RAID are supported only before there is data on the drives, or the case in which
there are no drives in the server.
If you migrate from using this embedded controller to a RAID controller card, you must disable the
embedded controller in the BIOS (see caution above).
Use the following procedure to disable the LSI MegaSR drivers.
Step 1 Boot the server and press F2 when prompted to enter the BIOS Setup utility.
Step 2 Select the Advanced tab, then South Bridge.
Step 3 Set Onboard SCU Storage Support to Disabled.
Step 4 Press F10 to save your changes and exit the utility.
Launching the LSI Embedded RAID Configuration Utility
Launch the utility by pressing Ctrl+M when you see the prompt during system boot.
For more information about using the Embedded MegaRAID software to configure your disk arrays, see
the
LSI Embedded MegaRAID Software User Guide.
Installing LSI MegaSR Drivers For Windows and Linux
Note The required drivers for this controller are already installed and ready to use with the LSI SWRAID
Configuration Utility. However, if you will use this controller with Windows or Linux, you must
download and install additional drivers for those operating systems.
This section explains how to install the LSI MegaSR drivers for the following supported operating
systems:
• Microsoft Windows Server 2008R2
• Red Hat Enterprise Linux (RHEL) 5.7, 6.1, and 6.2
• SuSE Linux Enterprise Server (SLES) 11 (SP1 and SP2)
This section contains the following topics:
• Downloading the LSI MegaSR Drivers, page C-12
• Microsoft Windows Driver Installation, page C-12
• Linux Driver Installation, page C-14