Filter
Top Products
IPmux-1/1E Installation and Operation Manual Appendix E Configuration Menus
General Configuration E-11
Table E-4. Manager List Parameters
Parameter Possible Values Remarks
Manage IP Address 0.0.0.0. to
255.255.255.255
Sets the Manager IP address
Link Up/Down Trap
On, Off
Link Down informs the Manager that there is a
physical failure.
Link Up informs the Manager that the device has
recovered from the failure.
Alarm Trap
On
Off
The alarm trap informs the manager of the
occurrence of any alarm enabled in the Alarms
Trap Mask screen. It informs the manager of both
entry and exit from an alarm state.
No Alarm Trap will be sent regardless of the Mask
defined in the Alarm Trap Mask screen
VLAN Tagging
Yes, No
See Chapter 1 for an explanation of VLAN tagging.
Yes: set options 4 and 5 on the System
Configuration Menu
VLAN ID 0 to 4095
Default: 0
VLAN Priority 0 to 7
Default: 0
Alarm Traps Mask
Each of the IPmux-1/1E alarms can activate a trap toward the NMS. It is possible to
enable/disable the trap operation for each one of the alarms, using the Alarm Trap
Mask screen.
ALARM TRAPS MASK
1. Alarm ID <refer to Manual> 1
2. Trap Status Active
Alarm Active Traps:
Select item from the menu.
Use <Esc> key or keys <1> to <2>
Figure E-15. Alarm Traps Mask Menu
Table E-5. Alarm Traps Mask Parameters
Parameter Possible Values Remarks
Alarm ID
1, 2, 6, 8, 21, 26
IPmux-1/1E alarm
Trap Status
Active
Masked
Generates an alarm
Does not send an alarm
Default for all traps: Masked
Main Menu
↓
2. Configuration
↓
1. General
Configuration
↓
2. Management
Configuration
↓
3. Alarm Traps
Mask