Filter
Top Products
4-11
Cisco Service Control Engine 1000 2xGBE Quick Start Guide
OL-7822-06
Chapter 4 Connect the Management Interfaces and Perform Initial System Configuration
Perform the Initial System Configuration
3. Type the default domain name to be used, and press press Enter.
4. Configure the primary domain name server .
5. Configure any additional domain name servers.
6. Exit the dialog.
DETAILED STEPS
Step 1 Enter the DNS settings menu.
Would you like to enter the DNS configuration menu? [no]: y
Type y and press press Enter.
The DNS settings dialog begins.
Step 2 Enable or disable DNS lookup.
• To enable DNS lookup, press press Enter.
• To disable DNS lookup, type n and press press Enter.
Enable IP DNS-based hostname translation? [yes]:
If you choose to disable DNS lookup, skip the rest of this section and go to . The rest of the dialog is not
presented, as it is irrelevant when DNS lookup is disabled.
Step 3 Type the default domain name to be used, and press press Enter.
Note that there is no default domain name.
You may accept the default domain name or enter a new one.
Enter default domain name []:
Step 4 Configure the primary domain name server .
Type the IP address of the primary domain name server and press press Enter.
Enter Primary DNS IP address:
Note that there is no default for this parameter.
Step 5 Configure any additional domain name servers.
You may configure up to three domain servers.
Would you like to add another Name Server? [no]:
• To exit the DNS settings dialog, press press Enter.
• To add another domain server, type y and press press Enter.
You are asked to enter the IP address of the next domain name server.
Enter Secondary DNS IP address:
Step 6 Exit the dialog.
When IP addresses for all servers have been entered, exit the dialog by pressing press Enter.
Would you like to add another Name Server? [no]:
EXAMPLE:
Following is a sample DNS configuration dialog. The default domain name is pcube.com, and the IP
address of the Domain Name Server is 10.1.1.230.