Filter
Top Products
6-2
Cisco Service Control Engine 1000 2xGBE Quick Start Guide
OL-7822-06
Chapter 6 Completing the Installation
Viewing Configuration
Step 1 To display the operation status of the system, at the SCE 1000# prompt, type show system
operation-status
and press press Enter.
A message displaying the operation status of the system appears. If the system is operating in order, the
following message appears:
System Operation status is Operational.
Example:
The following example displays a sample output where the LEDs appear red/orange:
SCE 1000numbershow system operation-status System Operation status is Operational
Viewing the User Log Counters
View the user log for errors that occurred during the installation process.
To display the user log device counters, complete the following steps:
Step 1 At the SCE 1000# prompt, type show logger device User-File-Log counters and press press Enter.
EXAMPLE:
The following example shows the current User-File-Log device counters.
SCE 1000numbershow logger device user-file-log counters Logger device User-File-Log
counters:
Total info messages: 1
Total warning messages: 0
Total error messages: 0
Total fatal messages: 0
If there are “Total error messages” or “Total fatal messages”, use the show logger device User-File-Log
command to display details about the errors.
Viewing Configuration
When you enter configuration commands, it immediately effects the SCE platform operation and
configuration. This configuration, referred to as the
running-config , is saved in the SCE platform
volatile memory and is effective while the SCE platform is up. After reboot, the SCE platform loads the
startup-config , which includes the non-default configuration as saved by the user, into the
running-config.
The SCE platform provides commands for:
• Viewing the running configuration
• Viewing the startup configuration