Filter
Top Products
4-4
PA-2FE-TX and PA-2FE-FX Two-Port Fast Ethernet Port Adapter Installation and Configuration
OL-3474-07
Chapter 4 Configuring the PA-2FE
Configuring the Interfaces
Note If you need to shut down additional interfaces, enter the interface fastethernet command
followed by the interface address (example: 1/1/1) of the interface. Use the no shutdown
command to enable the interface.
Step 4 Write the new configuration to NVRAM as follows:
Router# copy running-config startup-config
[OK]
Router#
The system displays an OK message when the configuration has been stored in NVRAM.
Step 5 Verify that new interfaces are now in the correct state (shut down) using the show interfaces command
(followed by the interface type and interface address of the interface) to display the specific interface.
Cisco 7301 router interface, followed by the type
(fastethernet) and slot/port
(port-adapter-slot-number/
interface-port-number)
shutdown
The example is for interface 0 and interface 1 on a
PA-2FE in port adapter slot 1.
Router(config)# interface fastethernet 1/0
Router(config-if)# shutdown
Router(config-if)# interface fastethernet 1/1
Router(config-if)# shutdown
Ctrl-Z
Router#
Cisco 7304 PCI port adapter
carrier card in Cisco 7304
router
interface, followed by the type
(fastethernet) and slot/port
(module-slot-number/
interface-port-number)
shutdown
The example is for interface 0 and interface 1 of a
PA-2FE in a Cisco 7304 PCI port adapter carrier card in
module slot 3 of a Cisco 7304 router.
Router(config)# interface fastethernet 3/0
Router(config-if)# shutdown
Router(config-if)# interface fastethernet 3/1
Router(config-if)# shutdown
Ctrl-Z
Router#
Cisco 7401ASR router interface, followed by the type
(fastethernet) and slot/port
(port-adapter-slot-number/
interface-port-number)
shutdown
The example is for interface 0 and interface 1 on a
PA-2FE in port adapter slot 1.
Router(config)# interface fastethernet 1/0
Router(config-if)# shutdown
Router(config-if)# interface fastethernet 1/1
Router(config-if)# shutdown
Ctrl-Z
Router#
VIP in Cisco 7500 series
routers
interface, followed by the type
(fastethernet) and slot/port
adapter/port
(interface-processor-slot-number/
port-adapter-slot-number/
interface-port-number)
shutdown
The example is for interface 1 and interface 0 on a
PA-2FE in port adapter slot 1 of a VIP installed
in interface processor slot 1.
Router(config)# interface fastethernet 1/1/1
Router(config-if)# shutdown
Router(config-if)# interface fastethernet 1/1/0
Router(config-if)# shutdown
Ctrl-Z
Router#
Table 4-1 Examples of the shutdown Command for the Supported Platforms (continued)
Platform Command Example