Filter
Top Products
4-18
PA-2FE-TX and PA-2FE-FX Two-Port Fast Ethernet Port Adapter Installation and Configuration
OL-3474-07
Chapter 4 Configuring the PA-2FE
Checking the Configuration
Dual Port Fast Ethernet (MMF), 2 ports
EEPROM format version 4
HW rev 1.00, Board revision UNKNOWN
Serial number:MIC04291ZUY Part number:73-5419-01
Note For complete command descriptions and examples for the VIP, refer to the publications listed in the
“Related Documentation” section on page viii.
Using the show interfaces Command
Display status information (including the physical slot and interface address) for the interfaces you
specify using the show interfaces command.
For complete descriptions of interface commands and the configuration options available for the
individual platforms, refer to the publications listed in the “Related Documentation” section on
page viii.
Note The outputs that appear in this document may not match the output you receive when running these
commands. The outputs in this document are examples only.
The following sections provide platform-specific output examples using the show interfaces command:
• Cisco 7100 Series Routers—Example Output of the show interfaces Command, page 4-18
• Cisco 7200 Series Routers and Cisco 7200 VXR Routers—Example Output of the show interfaces
Command, page 4-19
• Cisco 7201 Router—Example Output of the show interfaces Command, page 4-20
• Cisco 7401ASR Router—Example Output of the show interfaces Command, page 4-20
• VIP in Cisco 7500 Series Routers—Example Output of the show interfaces Command, page 4-21
Cisco 7100 Series Routers—Example Output of the show interfaces Command
Following is an example of the show interfaces command from a Cisco 7140 series router.
In this example, the two Fast Ethernet interfaces (0 and 1) are on a port adapter installed in port adapter
slot 4 of a Cisco 7140 series router; also, most of the status information for each interface is omitted.
(Interfaces are administratively shut down until you enable them.)
Router# show interfaces fastethernet 4/1
FastEthernet4/1 is up, line protocol is up
Hardware is i82543 (Livengood), address is 00b0.4a3c.e071 (bia 00b0.4a3c.e071)
Internet address is 10.0.0.1/8
MTU 1500 bytes, BW 100000 Kbit, DLY 100 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA, loopback not set
Keepalive set (10 sec)
Full-duplex, 100Mb/s
ARP type:ARPA, ARP Timeout 04:00:00
Last input 00:00:43, output 00:00:06, output hang never
Last clearing of "show interface" counters 00:03:54
Queueing strategy:fifo
Output queue 0/40, 5 drops; input queue 0/75, 0 drops
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec