Filter
Top Products
4-19
PA-2FE-TX and PA-2FE-FX Two-Port Fast Ethernet Port Adapter Installation and Configuration
OL-3474-07
Chapter 4 Configuring the PA-2FE
Checking the Configuration
26 packets input, 4922 bytes
Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
0 input errors, 1 CRC, 0 frame, 0 overrun, 0 ignored
0 watchdog
0 input packets with dribble condition detected
50 packets output, 7016 bytes, 0 underruns
0 output errors, 0 collisions, 0 interface resets
0 babbles, 0 late collision, 0 deferred
1 lost carrier, 0 no carrier
0 output buffer failures, 0 output buffers swapped out
Note To use the show interfaces fastethernet command with the Cisco 7120 series router, replace the
interface address arguments 4/0 and 4/1, with 3/0 and 3/1, respectively.
Cisco 7200 Series Routers and Cisco 7200 VXR Routers—Example Output of the show interfaces Command
Following is an example of the show interfaces fastethernet command from a Cisco 7200 series router
with a Fast Ethernet interface on a PA-2FE installed in slot 2:
Router# show interfaces fastethernet 2/0
FastEthernet2/0 is up, line protocol is up
Hardware is i82543 (Livengood), address is 0030.1983.b438 (bia 0030.1983.b438)
MTU 1500 bytes, BW 100000 Kbit, DLY 100 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA, loopback not set
Keepalive set (10 sec)
Half-duplex, 100Mb/s, 100BaseTX/FX
ARP type:ARPA, ARP Timeout 04:00:00
Last input 00:00:06, output 00:00:09, output hang never
Last clearing of "show interface" counters 00:01:29
Queueing strategy:fifo
Output queue 0/40, 0 drops; input queue 0/75, 0 drops
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
2 packets input, 690 bytes
Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
0 watchdog
0 input packets with dribble condition detected
14 packets output, 2220 bytes, 0 underruns
0 output errors, 0 collisions, 0 interface resets
0 babbles, 0 late collision, 0 deferred
1 lost carrier, 0 no carrier
0 output buffer failures, 0 output buffers swapped out
Note For the Cisco 7206 router shelves, the show interfaces command requires a shelf number in the format
show interfaces type shelf number/port adapter slot/port.