Filter
Top Products
9-6
Software Configuration Guide—Release 12.2(25)EWA
OL-7659-03
Chapter 9 Configuring Switches with Web-Based Tools
Configuring and Using the Network Assistant
If you plan to use clustering, enter the cluster run global configuration command on each device and
enter the ip address interface configuration command on the cluster commander:
Launching the Network Assistant
After installing Network Assistant, you will see its icon on your desktop. You will also see a Network
Assistant entry under Start > Programs and a Network Assistant executable file in the installation
directory. When you select any of these items, two windows will appear: the Network Assistant window,
in disconnect mode, and the Connect window.
Step 3
Switch(config-if)# ip address
ip_address
address_mask
(Optional) Assigns an IP address to the Catalyst 4500 series
Note This step is mandatory if the switch is part of
community or is a cluster command switch. This step
is optional if the switch is a cluster member
candidate.
Step 4
Switch(config-if)# end
Returns to privileged EXEC mode.
Step 5
Switch# show running-config
Verifies the configuration.
Command Purpose
Command Purpose
Step 1
Switch# configuration terminal
Enters global configuration mode.
Step 2
Switch(config)# cluster run
Enables clustering.
Note Enable clustering on all switches that are part of the
potential cluster.
Step 3
Switch(config)# cluster enable
Names the cluster.
Step 4
Switch(config)# interface {vlan
vlan_ID
|
{fastethernet | gigabitethernet}
slot/interface
| Port-channel
number
}
Selects an interface.
Step 5
Switch(config-if)# ip address
ip_address
address_mask
(Optional) Assigns an IP address to the Catalyst 4500 series
switch cluster master.
Note This step is mandatory if the switch is part of a
community or is a cluster command switch. This step
is optional if the switch is a cluster member
candidate.
Step 6
Switch(config-if)# end
Returns to privileged EXEC mode.
Step 7
Switch# show running-config
Verifies the configuration.