Filter
Top Products
4-16
Software Configuration Guide—Release 12.2(25)SG
OL-7659-02
Chapter 4 Configuring Interfaces
Monitoring and Maintaining the Interface
• logging event link-status use-global - This is the default link status logging event configuration on
the interface; its configuration should follow the switch global link status logging event setting.
The interface trunk status logging event can be configured in the same configuration states.
Configuring Link Status Event Notification for an Interface
To enable/disable a link status logging event, enter one of the following commands:
Global Settings
You can also provide a global configuration for the corresponding logging event. A global configuration
provides default logging settings for all interfaces. The [no] logging event link-status global command
lets you enable/disable the interface link status logging for the entire switch. The [no] logging event
trunk-status global command lets you enable/disable interface trunk status logging for the entire
switch.
Each interface link status logging event, if not configured at the interface level, will use the following
global logging event setting:
• logging event link-status global - Link status logging event is enabled, if not configured on the
interface.
• no logging event link-status global - Link status logging event is disabled, if not configured on the
interface.
The interface trunk status logging event has similar global configurations.
Configuring a Switch Global Link Status Logging Event
To enable/disable the global link status logging event, enter one of the following commands:
Command Purpose
Switch(config-if)# logging event link-status
Enables interface link status logging.
Switch(config-if)# no logging event link-status
Disables interface link status logging.
Switch(config-if)# logging event link-status use-global
Specifies the global default setting for interface link status
logging.
Command Purpose
Switch(config-if)# logging event link-status global
Enables global link status logging.
Switch(config-if)# no logging event link-status global
Disables global link status logging.