Filter
Top Products
Chapter 3 Disassembly and Maintenance
3-5. Disassembly, Reassembly and Lubrication
3-33 CL-S700/CL-S703/CL-S700R
3-5-18. Disassembling the Rewinder Part (CL-S700R Only)
Disassembly procedures for the Rewinder part of CL-S700R are explained here.
[Parts to be lubricated]
When the following parts are replaced or reassembled, apply grease (Floil G-311S).
The places to be lubricated are indicated with the mark in the drawings for the Rewinder Part
(the latter half) of Chapter 5 “Parts List”.
Drawing No. 2 “Unit, Rewinder”:
• ”Shaft, Measure Sensor” [2-1]: Both ends of the shaft (2 places)
• ”Shaft, Damper” [2-6]: Both ends of the shaft (2 places)
• “SA, Rewinder Motor” [2-8]: Contacting surface with the “Guide, Motor Plate” [2-10] (1 place)
• “Guide, Motor Plate” [2-10]: Back surface (1 place)
• “Shaft, Handle Plate” [2-24]: Both ends of the shaft (2 places)
• “Plate, Handle” [2-28]: Both holes for the “Shaft, Handle Plate” [2-24] (2 places)
• “SA, Handle Link” [2-29]: Both studs (2 places)
• “Frame, Door L” [2-33]: “Shaft, Door” [2-40] (1 place)
• “Frame, Door R” [2-43]: “Shaft, Door” [2-40] (1 place)
• “Holder, Door Shaft R” [2-44]: Hole for “Shaft, Door” [2-40] (1 place)
Drawing No. 3 “SA1, Peeler”:
• “Roller, Idle Rewinder” [3-1]: Both ends of the shaft (2 places)
• “Bush, Idle” [3-2]: Right side (2 places)
• “Roller, Friction” [3-6]: Both ends of the shaft (2 places)
• “Plate, Sensor Holder” [3-8]: Rear surface at both ends where circled with a dotted line (2
places)
Drawing No. 4 “SA2, Peeler”:
• “Roll, Peel” [4-1]: Both ends of the shaft (2 places)