Filter
Top Products
Chapter 3 Disassembly and Maintenance
3-5. Disassembly, Reassembly and Lubrication
CL-S700/CL-S703/CL-S700R 3-36
(2) Removing the Rewinder Mechanism block
1. Remove 2 screws (1PH (SW+PW), M3x5) and detach the “Case, Rewinder Front L”
upwardly.
2. Remove 1 screw (2PH (SW+PW), M3x5) and detach the “Case, Rewinder Front R”
upwardly.
3. Remove 1 screw (3PH (SW+PW), M3x5) and detach the “Plate, Torque Limiter”.
4. Disengage 1 E-ring (4E-Ring, 4), pull out “Pin, Parallel(A), M2x12” (5), and fully move the
Door Shaft block to the right. Then, pull out the Torque Limiter to the left.
Note on reassembling:
• The Torque Limiter can turn in one way only.
5. Disconnect 2 cables from the connectors J503 and J504 of the “SA, Rewinder PCB”.
Note on reassembling:
• Run the cables as shown in the figure.
6. Remove 7 screws (6PH (SW+PW), M3x5) and detach the Rewind Mechanism block
upwardly.
3
4
Plate, Torque Limiter
Torque Limiter
(Door Shaft Block)
Pin, Parallel(A), M2x12
E-Ring, 4
5
Case, Rewinder Front L
Case, Rewinder Front R
(Rewinder Mechanism
Block)
J503
J504
SA, Rewinder PCB
2
1
6
6