Filter
Top Products
Chapter 3 Disassembly and Maintenance
3-5. Disassembly, Reassembly and Lubrication
CL-S700/CL-S703/CL-S700R 3-40
(6) Removing the “SA, Interlock SW”
1. Remove the Rewinder Mechanism block referring to “(2) Removing the Rewinder
Mechanism block”.
2. Disconnect the cable of the “SA, Interlock SW” from the “SA, Rewinder Motor”.
3. Remove 2 screws (PH (PW), M2x10) and detach the “Plate, Nut” and the “SA, Interlock
SW”.
Note on reassembling:
• Horizontal long hole is provided for mounting the lower side of the “SA, Interlock SW”.
When assembling the “Plate, Nut”, be sure that the lower side of screw is at the center of the
long hole as shown in the figure.
SA, Interlock SW
Connector of the
SA, Rewinder Motor
PH (PW), M2x10
Plate, Nut
Long hole
Plate, Nut