Filter
Top Products
Chapter 3 Disassembly and Maintenance
3-5. Disassembly, Reassembly and Lubrication
CL-S700/CL-S703/CL-S700R 3-38
(4) Removing the “SA, Peel Sensor”/Friction Roller/Idle Rewinder Roller
1. Remove the “SA1, Peeler” referring to above “(3) Removing the “Door, Rewinder” and “SA1,
Peeler””.
2. Remove 2 screws (1BH, M3x5) and detach the “Plate, Friction Peeler”.
Then, the edges “A” of “Plate, Friction Link” on both sides are set free as they come off the
slits “B”, and both “Plate, Friction Link” become loose.
3. Remove 2 “Bush, Friction” (2) and detach the “Roller, Friction”.
4. Remove 2 screws (3PH, M2x3) and detach the “SA, Peel Sensor”.
5. Remove 3 “Bush, Idle” (4), 1 “Bush, Friction” (2), 2 “Plate, Friction Link”, “Spring, R
Friction” and “Spring, L Friction”, and detach the “Roller, Idle Rewinder”.
6. Disengage 1 E-ring (6E-Ring, 2) from the “Roller, Idle Rewinder”.
7. Remove 2 screws (7PH (SW+PW), M3x5) and detach the “Plate, Sensor Holder” from the
“Plate1, Peeler”.
Notes on reassembling:
• Distinguish the “Spring, L Friction” from “Spring, R Friction” referring to above figure.
The former is longer than the latter.
• Securely insert the edges “A” of the “Plate, Friction Link” into the slits “B”.
Roller, Idle Rewinder
1
2
3
Plate, Friction Peeler
2
Roller, Friction
4
SA, Peel Sensor
6
4
5
Plate, Friction Link
Spring, L Friction
Spring, R Friction
Plate, Sensor Holder
7
Plate1, Peeler
A
A’