Filter
Top Products
— 123 —
ESC S
[Function] Selecting STANDARD MODE
[Code] <1B>H<53>H
[Outline] Switches from PAGE MODE to STANDARD MODE.
[Caution] • This command is only effective if it is entered when in PAGE MODE.
• Any data mapped in PAGE MODE is erased.
• After this command is executed, the beginning of the line is taken as the next print
start position.
• The print area defined by ESC W is initialized.
• The commands listed below, which have separate settings for STANDARD MODE
and PAGE MODE, are changed to the settings for STANDARD MODE use.
(1) Spacing setting: ESC SP, FS S
(2) Line feed width setting: ESC 2, ESC 3
• The following commands are valid only in setting in STANDARD MODE.
(1) ESC W Sets the space amount for setting print area in PAGE MODE.
(2) ESC T Selects the printing direction of character in PAGE MODE.
(3) GS $ Sets the absolute position of character vertical direction in PAGE
MODE.
• STANDARD MODE is selected when the printer is turned on or reset, or when ESC
@ is executed.
[See Also] FF, ESC FF, ESC L