Filter
Top Products
— 93 —
• Setting memory switch 2 (a = 2)
n b (Set Value) Function
1 49 (Default) Reserved
2
48 Disables auto cutter.
49 (Default) Enables auto cutter.
3
48 (Default) Enables stored printing.
49 Disables stored printing.
4
48 Sets printing at full columns to be the same as CBM1000.
49 (Default) Sets printing at full columns to be the same as EPSON.
5
48 (Default) After cover close and PE recovery, prints as it is.
49 After cover close and PE recovery, prints from the
beginning using PAGE MODE, barcode, image,
double-height printing, etc. as a unit.
6
48 (Default) Sets paper width to 80 mm.
49 Sets paper width to 58 mm.
7 48 (Default) Reserved
8
48 (Default) Enables NPE.
49 Disables NPE.
• Setting memory switch 3 (a = 3)
n b (Set Value) Function
1
48 (Default) After clearing cutter error, can be restored by Feed SW.
49 After clearing cutter error, cannot be restored by Feed SW.
48 (Default) When selecting cover open error as recoverable error,
2
recovered by cover close.
49 When selecting cover open error as recoverable error,
recovered by command.
3
48 (Default) Resets with parallel pin 31.
49 Does not reset with parallel pin 31.
4
48 (Default) Uses thermal paper.
49 Uses Black mark paper.
5
48 (Default) Used with 48/32 print columns.
49 Used with 42/30 print columns.
6 48 (Default) Undefined
7
48 (Default) Sets CBM1000-noncompatible mode.
49 Sets CBM11000-compatible mode.
48 (Default) Sets cover open error during printing to be auto recovery
8
error.
49 Sets cover open error during printing to be recoverable
error.