Filter
Top Products
Chapter 5: Programming commands130
A776 (B780) Programming Guide A776-PG00001 C 12/09
Set Gateway
ASCII US BS ETX n1 n2 n3 n4
Hexadecimal 1F 08 03 n1 n2 n3 n4
Decimal 31 8 3 n1 n2 n3 n4
Default: none
Sets the printer to the gateway having the IP address value specied by the values n1 to n4. A gateway, even when the
printer is on another subnet, is not always needed.
The printer initiates no connection and obtains the gateway address from the host packets.
Set raw TCPIP port 9001
ASCII US BS EOT n1 n2 n3 n4
Hexadecimal 1F 08 04 n1 n2 n3 n4
Decimal 31 8 4 n1 n2 n3 n4
n1 = 0: disabled
n1 = 1: enabled
Default: enabled
Sets the port where the printer will look for raw tcpip communications.
LP Daemon
ASCII US BS ENQ n1
Hexadecimal 1F 08 05 n1
Decimal 31 8 5 n1
n1 = 0: disabled
n1 = 1: enabled
Default: disabled
Enables or disables the printer LP Daemon. The LP listens on port 515.
Telnet Daemon
ASCII US BS ACK n1
Hexadecimal 1F 08 06 n1
Decimal 31 8 6 n1
n1 = 0: disabled
n1 = 1: enabled
Default: enabled
Enables or disables the printer Telnet server. The Telnet server listens on port 23.
BootP
ASCII US BS BELL n1
Hexadecimal 1F 08 07 n1
Decimal 31 8 7 n1
n1 = 0: disabled
n1 = 1: enabled
Default: disabled
Enables or disables the use of BootP at power-up to obtain an IP address. BootP is a subset of DHCP.