Chapter 5: Programming commands84
A776 (B780) Programming Guide A776-PG00001 C 12/09
Transmits the printer ID specied by n as follows:
n Printer ID Specication ID (Hexadecimal)
1, 49 Printer model ID CognitiveTPG A776 0x2B (A776)
0x2A (A760)
0x28 (A758)
0x26 (A756)
0x2C (B780)
0x0A (A721)
2, 50 Type ID Installed options Refer to the table below
3, 51 ROM version ID ROM version 0x00
4, 52 Logo denition Logo denition Refer to table
next column
n = 2 or 50: Type ID
Type ID (n = 2)
Bit O/On Hex Decimal Function
0 O 00 0 No two-byte character
code installed.
On 01 1 Two-byte character
code installed.
1 O 00 0 No knife installed.
On 02 2 Knife installed.
2 - - - Undened.
3 O 00 0 No MICR installed.
On 08 8 MICR installed.
4 O 00 0 Not used. Fixed to O.
5 O 00 0 No imager installed.
On 20 32 Imager installed.
6 - - - Undened
7 O 00 0 Not used. Fixed to O.
n = 4 : Logo Denition
Bit O/On Hex Decimal Function
0 O 00 0 No logo denition loaded by application.
On 01 1 Logo loaded by application
1 - - - Undened
2 - - - Undened
3 - - - Undened
4 O 00 0 Not used, Fixed to O.
5 - - - Undened
6 - - - Undened
7 O 00 0 Not used, Fixed to O.
Transmits the printer ID specied by n. This command is a batch mode command; that is, the response is transmitted
after all prior data in the receive buer has been processed. There may be a time lag between the printer receiving this
command and transmitting the response, depending on the receive buer status.