Filter
Top Products
Chapter 5: Programming commands80
A776 (B780) Programming Guide A776-PG00001 C 12/09
Original attribute mapped table
m bit on attribute mapped
0 Bold
1 Italic
2 Reverse
3 Underline
4 Double high
5 Double wide
6 Compressed print
The following “s” bits and “m” bit 7 set the attributes that substitute for the mapped set:
Attributes substituted table
m bit on attributes substituted
7 Bold substituted
s bit on attributes substituted
0 Italic
1 Reverse
2 Underline
3 Double high
4 Double wide
5 Compressed print
6 Alternate color
7 Color reverse
This command congures into EEPROM (permanent conguration switch setting) one or two combinations of
character attribute mappings, including substitute attribute settings for color eects. The attributes of the character
code are used to form the desired pixel character when the code is placed into the raster print buer. An “m” bit value
set to on in the “original attribute mapped table” above will have its attributes set to the corresponding bit value of “s”
in the “attributes substituted table”. If m = 0 then no substitution takes place.
The command is available only in A776 native mode. Once attributes have been dened and enabled they can be
used in any emulation mode. A776 native mode must be used to turn the feature o.
The operational theory of this command is that if (input character attributes) AND (original) = (original); then (output
character attributes) = ([original] X OR [input character attributes]) OR (substituted). The input character’s original
attributes are mapped to the substituted attributes, but any attributes not specied for mapping are unchanged.
In the tables you will see that there are 7 input attributes and 9 outputs. It is expected that the alternate color attribute
will be used most. For example, when the alternate color attribute is combined with the reverse substitution attribute,
the result is white characters on a color background. The color reverse attribute without alternate color will print black
text on a color background. Any mappings utilizing compressed and/or double-wide attributes will eect the length
of a line and could cause unintended line wraps. Mappings containing double-high attributes could cause unintended
receipt lengths.
When both attribute mappings are set, processing is perform in order sequence. When two text attribute substitutions
contain conicting dependent remappings, the result is undened.
Continued . . .