Filter
Top Products
Chapter 6: DH Emulation 149
A776-PG00001 C 12/09 A776 (B780) Programming Guide
Document Clamp Close
Closes the platen when the form has been detected and the time for the clamp delay is up. This command enables the
Slip/Validation paper feed and disables the Receipt/Journal paper feed.
Hexadecimal Decimal ASCII
1B 1C 27 28 ESC FS
Form Eject
Ejects the form from the validation station after it has been printed.
Hexadecimal Decimal ASCII
1B 41 27 65 ESC A
Download
This command is not supported and is ignored if received.
Hexadecimal Decimal ASCII
1B 42 75 27 66 117 ESC B u
Form In
This command is not supported and is ignored if received.
Hexadecimal Decimal ASCII
1B 46 27 70 ESC F
Select
This command is not supported and is ignored if received.
Hexadecimal Decimal ASCII
1B 47 27 71 ESC G
Either Form-In Sensor
This command is not supported and is ignored if received.
Hexadecimal Decimal ASCII
1B 49 27 73 ESC I
Both Form-In Sensors
This command is not supported and is ignored if received.
Hexadecimal Decimal ASCII
1B 4A 27 74 ESC J
Busy Until Buer Empty
Changes the state of the RTS (Request to Send) line until the buer is empty. This command is processed immediately.
Hexadecimal Decimal ASCII
1B 4B 27 75 ESC K
Clamp Delay
Sets the time that the printer waits from when it detects an inserted form to when it clamps the platen closed. This
allows time for the form to be lined up correctly and held still.
Hexadecimal Decimal ASCII Value of n
1B 4C n 27 76 n ESC L n See table
Value of n
Hexadecimal Decimal ASCII Time of Clamp Delay
00 0 NUL No delay
01 1 SOH 0.250 seconds
02 2 STX 0.500 seconds (default)
03 3 ETX 1.00 seconds