Filter
Top Products
Chapter 5: Programming commands 81
A776-PG00001 C 12/09 A776 (B780) Programming Guide
Related information
This command is utilized in the CognitiveTPG LogoEZ
®
utility. The utility can be used to pre-congure new printers with
a default colorization set-up without requiring any application changes. The default set-up was designed to provide a
general level of colorization features that would not aect the printer operation. You can expand beyond the default
features of the utility by modifying the application at the host. However, do not attempt to modify the settings within
the utility.
f = 1: s = 1H
a = 30H
f = 2: s = 32H
r = 19H
f = 3: s = 1H
r = 7H
t = 1H
f = 4: s = 30H
a = A0H
Convert 6-dots/mm bitmap to 8-dots/mm bitmap
ASCII US EOT n
Hexadecimal 1F 04 n
Decimal 31 04 n
Value: 0 = O
1 = On
(When 0 and 1 are the LSB)
Default: 0 (O)
Selects or cancels 6-dot/mm to 8-dot/mm graphic emulation.
When the 6-dot/mm emulation is selected, logos and graphics are expanded horizontally and vertically during
download to emulate their size on a 6-dot/mm printer. The horizontal positioning commands also emulate positioning
on a 6-dot/mm printer.
Enable constant speed logos
ASCII US { n
Hexadecimal 1F 7B n
Decimal 31 123 n
Value: 0 = disabled
1 = enabled
This command allows the rmware to determine the optimal speed to print a logo. It is set prior to downloading the
logo and reset after the logo has been downloaded.
In general, the “Set max target speed (1D A0 nl nh)” is the preferred command.