Filter
Top Products
Chapter 5: Programming commands40
A776 (B780) Programming Guide A776-PG00001 C 12/09
Select sensors to stop printing
ASCII ESC c 4 n
Hexadecimal 1B 63 34 n
Decimal 27 99 52 n
Value of n: Sensor status
Default: 0
Bit of n
Bit Function
0,1 Stop receipt on receipt low
4 Stop slip if trailing edge uncovered
5 Stop slip if leading edge uncover
7 Stop validation print if trailing edge uncovered
(B780 only)
Determines which sensor stops printing on the respective station. The command does not aect the paper out status
on the receipt station, which will automatically stop the printer when the paper is depleted.
Enable or disable panel button
ASCII ESC c 5 n
Hexadecimal 1B 63 35 n
Decimal 27 99 53 n
Value of n: 0 = Enable
1 = Disable
Default: 0 (Enable)
Enables or disables the paper feed button. If the last bit
is 0, the paper feed button is enabled. If the last bit is 1, the paper feed button is disabled.
Related information
Functions that require the paper feed button (except for the execute macro [1D 5E r t m] command) cannot be used
when it has been disabled with this command.
Set slip paper waiting time
ASCII ESC f m n
Hexadecimal 1B 66 m n
Decimal 27 102 m n
Value of m: Not used
Value of n: Tenths of seconds
The time that the printer waits for a slip to be inserted is set using the conguration menu. The default is forever, but it
can be set to 1, 3, or 5 minutes.
The value “n” sets the time (n x 0.1 seconds) that the printer waits to close the platen and start printing after the slip has
been inserted. The printer reads that a slip is inserted when the leading edge and trailing edge sensors are covered.
The slip-in light is lit (green) when both sensors are covered.
If a slip is not inserted in the time specied, the receipt station is selected for the next function.