Filter
Top Products
. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
1-9
Compaq Netelligent 2724/2824 Dual-Speed Hub User Guide
Writer:
Chris Seiter
Project:
Compaq Netelligent 2724/2824 Dual-Speed Hub User Guide
Comments:
299440-001
File Name:
2824_1.DOC
Last Saved On:
6/27/97 4:02 PM
See Chapter 4 “Configuring the Hub for Management” and Appendix B “Using
the VT100 Interface” for more information about the serial port.
Host/Target DIP Switch
On the back panel of the 2724 hub is a HOST/TARGET DIP switch that
determines whether the hub is a host or target hub in a hub stack. For example,
you can connect up to two 2724 hubs and designate one as the host and the
other hub as a target for an unmanaged stack. Or, if you have a managing hub
(2824) in the stack, you can set up to four 2724 manageable hubs as target hubs
for a managed stack. The 2824 hub does not have a HOST/TARGET DIP
switch.
NOTE
: There may be only one host hub in a stack. More than one host hub prevents
the stack from passing Ethernet traffic or management commands between units.
Figure 1- 5.
2724 Hub DIP Switches