Filter
Top Products
. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
B-2
Using the VT100 Interface
Writer:
Chris Seiter
Project:
Compaq Netelligent 2724/2824 Dual-Speed Hub User Guide
Comments:
299440-001
File Name:
2824_B.DOC
Last Saved On:
6/23/97 5:26 PM
Starting the VT100 Interface
After you make the required connections and set up the communications
program, follow these steps to start the VT100 interface.
NOTE
: The VT100 interface allows only one active user at a time. For example, if an
active VT100 session is using Telnet over Ethernet, another session cannot occur
over the serial or Ethernet connections.
1. Start the communications program. If you use a Telnet application, enter a
valid IP address and start the connection.
2. Enter the following command:
vt100
NOTE:
If the login fails, you may need to retry the connection several times.
The Login screen appears.
Figure B- 1.
Login Screen
3. Within 20 seconds after the Login screen appears, enter the password. The
default password is public. The Main menu screen appears.