Filter
Top Products
. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
1-11
Compaq Netelligent 2724/2824 Dual-Speed Hub User Guide
Writer:
Chris Seiter
Project:
Compaq Netelligent 2724/2824 Dual-Speed Hub User Guide
Comments:
299440-001
File Name:
2824_1.DOC
Last Saved On:
6/27/97 4:02 PM
If the switch is set to “10/100,” you can force 10 Mb/s connections using the
n2fePortAutoNegCapAdvertised MIB variable. However, if the switch is set to
“10 ONLY,” the hardware forces the connection speed and cannot be changed
by the management agent. To view the status of this switch, see the
n2feForce10 Mb/sSwitchStatus MIB variable.
NOTE
: This switch must be set to 10 ONLY if you set the 10 MDI / 10/100 MDI-X
switch to 10 MDI.
Figure 1- 6.
Port 1 Switches
10 MDI - 10/100 MDI-X Switch
The 10 MDI / 10/100 MDI-X switch is located on the front panel of the 2724
and 2824 hubs. This switch lets you set Port 1 as an MDI 10Base-T (uplink)
port (for connecting to another hub) or as an MDI-X port (for connecting
directly to a network controller card). The 10 MDI setting is for 10Base-T
connections only.
NOTE
: If you set this switch to 10 MDI, be sure the 10 ONLY - 10/100 switch is set
to 10 ONLY.