Compaq 2824 Switch User Manual


 
. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
B-14
Using the VT100 Interface
Writer:
Chris Seiter
Project:
Compaq Netelligent 2724/2824 Dual-Speed Hub User Guide
Comments:
299440-001
File Name:
2824_B.DOC
Last Saved On:
6/23/97 5:26 PM
Unit Description — This field shows a brief description of the hub.
Backplane Configuration — The backplane connection status for the hub.
Select “Connected” or “Isolated” to connect the hub to or isolate it from the
stack’s common 100Mb/s Ethernet backplane. For Netelligent 2524 and 2624
hubs, which do not have this feature, this field always shows “Connected.”
Internal 10/100 Switch Configuration — Select “Disabled” to disable the
internal switch and isolate the 10Mb/s and 100Mb/s collision domains. Select
“Enabled” to enable the internal switch.
NOTE
: If the selected hub is a 2724 (manageable) unit and its internal 10/100
switch has been disabled via the hubs hardware DIP switch, you cannot enable the
switch using this field. For 2524 and 2624 hubs, this field always shows N/A.
Error Messages
The following error messages can occur while modifying the stack
configuration:
ERROR: This unit cannot be isolated from the backplane.
ERROR: Cannot enable/disable internal switch on this unit