Filter
Top Products
64 Chapter 4
Configuring and Using the 9900 Subsystem
Goto Filter Backup Query Help
.---------------------- Select Processor / Control Unit ----------------------.
| Row 1 of 1 More: > |
| Command ===> ___________________________________________ Scroll ===> PAGE |
| |
| Select processors to change CU/processor parameters, then press Enter. |
| |
| Control unit number . . : 8000 Control unit type . . . : 2105 |
| |
| Log. Addr. -------Channel Path ID . Link Address + ------- |
| / Proc. ID Att. (CUADD) + 1---- 2---- 3---- 4---- 5---- 6---- 7---- 8---- |
| S PROD __ _____ _____ _____ _____ _____ _____ _____ _____ |
| ***************************** Bottom of data ****************************** |
| |
| |
| |
| |
| |
| |
| |
| |
| F1=Help F2=Split F3=Exit F4=Prompt F5=Reset |
| F6=Previous F7=Backward F8=Forward F9=Swap F12=Cancel |
'-----------------------------------------------------------------------------'
| F6=Previous F7=Backward F8=Forward F9=Swap F12=Cancel |
'-----------------------------------------------------------------------------'
Figure 4.9 Selecting the Operating System (Step 6)
Goto Filter Backup Query Help
.--------------------------- Add Control Unit ----------------------------.
| |
| |
| Specify or revise the following values. |
| |
| Control unit number . : 8000 Type . . . . . . : 2105 |
| Processor ID . . . . . : PROD |
| |
| Channel path IDs . . . . 60 61 62 63 64 65 66 67 + |
| Link address . . . . . . __ __ __ __ __ __ __ __ + |
| |
| Unit address . . . . . . 00 __ __ __ __ __ __ __ + |
| Number of units . . . . 256 ___ ___ ___ ___ ___ ___ ___ |
| |
| Logical address . . . . 0_ + (same as CUADD) |
| |
| Protocol . . . . . . . . __ + (D,S or S4) |
| I/O concurrency level . 2 + (1, 2 or 3) |
| |
| |
| F1=Help F2=Split F3=Exit F4=Prompt F5=Reset F9=Swap |
| F12=Cancel |
'-------------------------------------------------------------------------'
Figure 4.10 Control Unit Chpid, CUADD, and Device Address Range Addressing (Step 7)