Filter
Top Products
Installation Procedures
AlterPath BladeManager Manual 2-15
6. Turn the DIMM so that the keys align with the slot.
7. Insert the DIMM into the connector by aligning the DIMM edges with the
slots at each end of the DIMM connector. Firmly press the DIMM straight
down into the connector by applying pressure on both ends of the DIMM
simultaneously. The retaining clips snap into the locked position when the
DIMM is firmly seated in the connector. If there is a gap between the
DIMM and the retaining clips, the DIMM has not been inserted correctly;
open the retaining clips, remove and reinsert the DIMM.
8. If you have other options to install, do so now.
9. Replace the cover.
10. Go to Completing the Installation, this chapter.
Installing a Hard Disk Drive
Follow the documentation that comes with the hard disk drive in addition to
the instructions in this chapter.
Installing a Simple-Swap Serial ATA Hard Disk
Drive
To install a simple-swap Serial ATA hard disk drive, complete the following
procedure:
Note: If you have only one hard disk drive, install it in the left drive bay.
1. Review the installation safety guidelines ar the beginning of this chapter.
2. Switch off the server and peripheral devices, and disconnect the power
cord and all external cables.
3. Press the release tabs on the bezel and pull the bezel away from the
server.
4. Slide the drive into the server until it connects to the backplane.
5. If you have other options to install, do so now.
6. Reinstall the bezel.
7. Go to Completing the Installation, this chapter.