Filter
Top Products
Updating the Server Configuration
AlterPath BladeManager Manual 2-23
Updating the Server Configuration
When you start the BladeManager for the first time after you add or remove
an internal option or external SCSI device, you might receive a message that
the configuration has changed. The Configuration/Setup Utility program
starts automatically so that you can save the new configuration settings.
Some options have device drivers that you need to install. See the
documentation that comes with the device information about installing any
required device drivers.
If the server has a RAID configuration using the SCSI controller with
integrated RAID (SCSI models only) or the integrated Serial ATA controller
with RAID and you have installed or removed a hard drive, you might have to
reconfigure your disk arrays. See the RAID documentation on the IBM
ServeRAID-7e (Adaptec HostRAID) Support CD for more information about
reconfiguring the disk arrays.
If the server has an optional RAID adapter and you have installed or removed
a hard disk drive, see the documentation that comes with the RAID adapter
for information about reconfiguring the disk arrays.
BladeManager Controls, LEDs, and Power
This section describes the controls and light-emitting diodes (LEDs) and how
to switch the BladeManager on and off.
Front View
The diagram below shows the controls and LEDs on the front of the
BladeManager.