Filter
Top Products
SOFTWARE CONFIGURATION
3
Parameter
Default Setting
Reading Parameters
Overflow Stop Ratio 5
Reading Mode Reconstruction
Reading Condition Standard
Reconstruction Parameters
Enabled Stacked Code Disabled (unchecked)
Extended
Min Match 0
Position Tolerance 50
Duration Tolerance 50
Min Start/Stop Number 2
Inter Char Gap 8
Addon Overflow Ration 2
Scan Line Amplitude
Amplitude Settings Enable (unchecked) Disabled
PackTrack Calibration
Direction 0 (Forward)
PS Offset 0
Data Communication Settings
Host Application Protocol Type Standard
Data Format
Header TX Start With data
Termination After No Read Message d (checked) Enable
Message Tx Trigger Selection Decoding On
Format Type tandard S
TX Max Delay After Phase Off Disabled
Code Identifier Disabled
Parameters
Header String <STX>
Code Position Disabled (unchecked)
Code Direction Identifier Enable isabled (unchecked) D
Termination String <CR><LF>
Data Packet Separators F> <CR><L
Code Field Length Setting Length Variable
Main Serial Port
Data Tx Enabled (checked)
Heartbeat Disable
Parameters
Main Port Communication Mode Standard
Main Port Electrical Interface RS232
Handshake None
Baud Rate 9600
Parity None
Data Bits 8
Stop Bits 1
51